Publicité
Les langues disponibles
Les langues disponibles
Illustration 4
Table base
1
1
/
" long wood
2
screw
Positioning
groove
242-0065D
www.hon.com
Mounting plate
Positioning
groove
©2015 The HON Company | HON is a registered trademark of HNI Technologies, under license to the HON Company.
4. Refer to Illustration 4. Use two or more people to lay
table top upside down on cardboard or a carpeted sur-
face.
Locate positioning grooves cut into bottom of table top.
Center table base onto table top and align corners of
mounting plate with positioning grooves cut into table
top.
Table top
Use the Phillips screwdriver to install eight 1
wood screws (from hardware pack) through holes in
mounting plate and into table top. Fully tighten screws.
5. Use two or more people to set table upright and posi-
tion table where it will be used.
6. Adjust glides until table is level.
/
" long
1
2
2 of 2
Publicité
