Wiring - AVARRO 0E-HDMIEX4KA Manuel

Wiring

Warnings:
Before wiring, disconnect the power from the device.

During wiring, connect and disconnect the cables gently.

ARC Mode:
Note: When you want to configure ARC channel feed by TV:
Ensure AV System and TV support ARC function and CEC should be enabled.
1. Switch the DIP switch on front panel of the receiver to ARC mode.
2. Connect an AV System to HDMI IN port of the transmitter.
3. Connect HDMI IN ports with ARC function supported of a TV to HDMI
OUT port of the receiver.
4. Connect HDBT OUT of the transmitter to HDBT IN port of the receiver.
5. Set CEC function of TV to on.
6. Switch the AV System to ARC channel.
7. Connect the provided power adapter to the transmitter or receiver.
8. Power on all attached devices. The audio signal of TV through HDMI OUT
port will be transmitted to the AV System connected to HDMI IN Port of
transmitter. (See Figure 1)
S/PDIF Pass-through Mode
1. Switch the DIP switch on front panel of the receiver to S/PDIF IN mode.
2. Connect an audio receiver to the S/PDIF OUT port of transmitter.
3. Connect an audio source to S/PDIF IN port of receiver.
4. Connect HDBT OUT port of the transmitter to HDBT IN port of the receiver.
5. Connect the provided power adapter to the transmitter or receiver.
For more information please call 1-833-574-9124 or email AVARRO@adiglobal.com
9
To learn more about AVARRO products visit avarro.adiglobaldistribution.us
···