Installation To Solid Concrete Surface - PEERLESS Mounts EPMU-05 Installation Et Assemblage

Installation to Solid Concrete surface

• Installer must verify that the supporting surface will safely support the combined load of the equipment and all
attached hardware and components.
• For attachment to concrete fl oor only. All eight concrete expansion anchors must be used.
• Tighten to 35 ft. • lb (47 N.M.) maximum torque.
Use support column (A) as a template to mark eight mounting holes on concrete fl oor. Drill eight 3/8" (10 mm) dia.
1
pilot holes to a minimum depth of 3" (76 mm) as shown. Place support column over mounting holes and secure
with eight concrete expansion anchors (B) as shown below. Tighten all fasteners.
WARNING
Tighten all fasteners. Tighten to 35 ft. • lb (47 N.M.) maximum
torque.
A
B
4 of 32
A
ISSUED: 06-22-10 SHEET #: 061-9053-6 01-15-11
concrete
fl oor
B