System Features - Party Light & Sound PARTY-200UHF Manuel D'utilisation

• Do not place the appliance on soft surfaces such as carpets or beds. Do not cover the air vents of the appliance. Do
not obstruct the air circulation with objects such as magazines, table cloths or curtains. This prevents the
dissipation of heat from the appliance and can result in overheating.
• Only use the appliance in a moderate climate, not in tropical environments.
• Defective mains cables may only be replaced by specialists. Danger of shock hazard!
• If you are not sure about the correct connection or if questions arise which are not answered by the operating
instructions, please do not hesitate to contact support or a specialist of your choice. Consult a specialist if you are
in doubt the operating principle or the safety of the product.

SYSTEM FEATURES

1. Multiple system use: Several UHF systems can be used in the same performance space. Each system must be set to
a different frequency (frequency marked on the back of the receiver).
2. Simultaneous output use: Unbalanced 6.35mm jack plug and balanced XLR output connectors may be used
simultaneously to different external devices.
3. Range: UHF series transmitters will work at a distance of up to 30m from the receiver.
4. Noise squelch: Squelch circuit analyzes signal strength and quality to avoid interference due to environmental RF
noise.
5. Low battery warning light: A red light on the microphone(s) warns the user that there is less than one hour of
battery life left.
DUAL CHANNEL RECEIVER
Front panel
1. Power Button: Power ON/OFF the receiver.
2. Power Indicator: Indicate the power ON/OFF.
3. Volume Knob channel 1.
4. Volume knob channel 2
5 & 6."RF" signal Indicator: It glows when the Receiver receives an RF signal from mic 1 & mic2.
7 & 8."AF"Audio Level Indicator: Indicate the wireless system audio signal level of channel 1 & 2.
9 & 10. Antenna channel 1 & 2
Rear panel.
11. 5Vdc Power Jack: Connect the AC/DC adapter to receiver
12. Audio Output Jack 6.35mm: Connect the audio cable from this jack to the input port of amplifier, mixer.
13. XLR Balanced Output Jack: Connect the audio cable from this jack to the input port of amplifier, mixer.
©Copyright Lotronic 2017 PARTY--200UHF 3