Publicité
Les langues disponibles
Les langues disponibles
English
1. Mount the basis plate on the revolver, and
fasten the 4 M8 screws [A].
2. Mount the hobbing head and place the 2 M6
screws [B]. Set the right angle, using the
setting screw [D] and the reference surface
[C]. Block the head by fastening the screws
[B].
3.
Put the hob cutter and the blocking nut [E]
on the shaft.
Zone industrielle C
Rte du Grammont 101
CH-1844 Villeneuve
Mode d'emploi
Operating instructions
Betriebsanleitung
Istruzioni per l'uso
KSH432
4. Mount the shaft support and fasten it with the
two screws [F].
5. -
MARK :
PCM WILLEN SA
SWISS MADE
Copyright © PCM Willen SA.
Garant:
KSH432-22Mode
BT
Validation: 03.11.21
Tél ++41 21 967 33 66
Fax ++41 21 960 38 95
http://www.pcm.ch
email:
office@pcm.ch
Document:
d'emploi .docx
Page: 2 de 2
Publicité
