mode earlier, power off the bulb via the wall switch, wait for
two seconds and then power it back on.
Rejoin wireless network:
•
Press and hold the button for minimum 10 seconds but no more
than 20 seconds. The bulb will blink two times indicating it
rejoined the network.
Factory default reset:
•
Press and hold the button for minimum 20 seconds. The bulb will
unpair from your home control or security system and then blink
five times followed by subtle light pulsing to indicate pairing mode.
Troubleshoot the device
Having trouble pairing with the controller?
•
Try moving the bulb to a location closer to the controller.
Remove obstacles or other wireless devices between the
bulb and the controller.
•
Ensure neither the bulb nor the controller is located near
other wireless devices such as a Wi-Fi access point/router.
Bulb was communicating with the controller, but controller
eventually loses control of the bulb.
•
Check if the power cord to the bulb has been disconnected or
if the power switch is in the OFF position.
•
Power cycle the bulb using the wall switch. The bulb should
rejoin the controller automatically.
•
If the previous steps do not resolve the problem, delete the
bulb from the controller, then follow the installation
instructions above to add the bulb again to the controller.
Important Safety Instructions
•
NOT FOR EMERGENCY LIGHTING
•
ADDED WEIGHT OF THE DEVICE MAY CAUSE INSTABILITY
OF A FREE-STANDING PORTABLE LUMINAIRE
•
USE ONLY WITH A PORTABLE TABLE LUMINAIRE THAT IS
PROVIDED WITH A SHADE
•
RISK OF ELECTRIC SHOCK-DO NOT USE WHERE DIRECTLY
EXPOSED TO WATER
•
This product is intended for indoor use only
•
It is not recommended to install this bulb in sockets controlled
as a group (ex: recessed lights, ceiling fan fixtures)
•
Operate the button on the bulb only when the bulb surface
temperature is not hot
•
Do not install the product near any heat sources, such as
heaters, radiators, stoves, heat registers or other apparatus
that produce heat
EN