Silver Cross Balance i-Size Mode D'emploi page 54

Balance
Car Seat Cover
Removal
3
On the top edge of the seat, pull the cover
up releasing it from the front edge. Then pull
downwards until the sides of the seat are
exposed.
6
Lift the back panel of the headrest up and
release the 4 poppers. Now the main section
of the cover can be lifted up and removed
from the seat.
9
Unhook the webbing from the metal clasp
on the tops of the shoulder straps.
Washing: The seat cover can be washed on
a delicate cycle at 30 degrees using a mild
detergent.
Take out all removable internal foam parts
from inside the insert before washing.
1
Removing main the cover
Remove the insert and Velcro crotch pad.
Pull the cover forwards directly in front of the
harness adjustment button.
Unhook and pull up the front edge of the
cover.
4
Pull the side of the cover upwards near the
belt guide, an elastic section will appear. This
needs to be pulled outwards and through the
gap between the belt guide and seat shell.
Push the belt guide outwards to open the
gap. Repeat on both sides.
7
Pull the headrest cover up from the lower
section, removing it from the headrest.
10
How to stow the harness for use with
adult seat belt: Ensure harness is loose to
enable the headrest to be used in the higher
positions. Follow step 1 & 2 of the main
instructions, lift the foam seat base and
push the buckle through the hole. Open the
flap on the base and store the buckle inside.
2
Pull the lower section of the seat cover
upwards.
5
Pull the internal section of the cover down
and out from the belt guide. Do this on both
sides.
8
Removing the shoulder pads
Open the Velcro on both of the shoulder
pads.
11
How to stow the harness for use with
adult seat belt (Continued): Open the
back panel of the seat as per step 6 of the
main instruction. Stow the harness behind
with the buckles positioned to the side. The
harness pads can be removed as per step (8).