Turning On The Appliance; Shutting Down; Transport - Kärcher BDS 33/180 C Mode D'emploi

Turning on the Appliance

Caution
Risk of damage to the floor covering. Do
not operate the appliance on the spot.
 Insert the mains plug into a socket.
 Set handle to working height.
 Hold the handle with both hands.
 Press and hold the unlocking button.
 Use the ON/OFF switch.
 Release the unlocking button.
 Release the switch to interrupt operation.
Control the direction
Left: Press the handle downward.
–
Right: Raise the handle.
–
Cleaning
 Apply the detergent solution to the floor
or use the dosing lever of the detergent
tank (option).
 Move the appliance over the surface to
be cleaned.
 Repeat process for severe contamina-
tion.
 Afterwards, pick up the wastewater with
a wet vacuum or a cloth.

Shutting down

 Disconnect the mains plug from the
socket.
 Loosen the clamps of the level adjust-
ment.
 Move the handle into a vertical posi-
tion.
 Tighten the clamps of the level adjust-
ment.
 Remove the detergent tank (option) and
dispose of unused detergent solution.
6
 Coil the mains cable as shown.
 Rinse the detergent tank (option) with
clear water.
 Place the appliance into the parking po-
sition.
 Remove the driver plate / disc brush.
 Clean the casing with a damp cloth.
Caution
Risk of injury and damage! Observe the
weight of the appliance when you transport
it.
 Loosen the clamps of the level adjust-
ment.
 Move the handle into a vertical posi-
tion.
 Tighten the clamps of the level adjust-
ment.
 Tilt the appliance backwards into the
transport position and drive it to its des-
tination location.
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
– 4
EN

Transport