Joouls JOOULY Mode D'emploi page 12

3. Adding Additional JOOULYs
It is possible to purchase additional JOOULYs to link with the one originally purchased.
If you wish to connect and synchronise an additional JOOULY, switch it on, it will automati-
cally connect with the Master JOOULY 'A' and will have the same music and lighting. When
using the remote control with the first connected JOOULY 'A', the music and light on all
connected JOOULYs will match.
Notes:
• Whichever JOOULY is connected initially to your Bluetooth device is the Master 'A'.
• If the ON/OFF button on 'A' is pressed for 2-3 seconds, the music and lighting on 'A' will
go OFF. On the other synchronised JOOULYs (B/C/D...), only the music will go OFF, but
the lights will remain ON.
• If you press the remote control to switch 'A' ON or OFF, all the other units' lighting will go
ON or OFF.
• If you press the ON/OFF button of a SYNC JOOULY (B/C/D), this JOOULY will disconnect
from the Master "A" –the other JOOULYs' music and lighting will remain connected.
• If 'A' is without power, or you wish to change 'A', or change to another smart device, you
first need to cancel the pairing of 'A' and then connect a new speaker/device.
• All speakers can be either a 'Master' or 'Slave' device.
4. Using the Remote Control
The remote control is for playback as well as lighting functions.
If the RC does not work, check the battery isolation tab has been pulled out before initial
use.
Note: The button type 'CR2025' test battery is factory fitted and may not have full charge. In
this case insert a new battery.
If you want the JOOULY to play music without LED lighting, press the red "OFF" button on
the remote control.
If you want the JOOULY to play music with lighting again, press any of the colour buttons.