Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
fresh water to the MAX fill level and place an empty cup on the
drip tray.
10.Set the on/off switch to the on position and wait for the water
to be dispensed into the cup.
11.Discard the water in the cup.
12.Repeat steps 10 and 11 until the water level is at the MIN
mark. Open the lid and empty any remaining water into the
sink (see the section «DE-SCALING THE APPLIANCE»).
Any other works should be performed in the authorized ser-
vice center.
Do not store the appliance if it is hot or connected to the
network. If you do not use the appliance, put it in a box after
cooling and store in a safe, dry place, out of children's reach.
List of possible problems:
Problem
Possible cause
The power on/off
The appliance hasn't
switch can not be
cooled down after
fixed in the operation
the last use
position
The appliance is not
connected to the
No backlighting in
mains supply
the water con-
The appliance is po-
tainer. The
sitioned incorrectly
appliance doesn't
on the base
heat water
Safety cut-off is burnt
No water in the ap-
pliance
The appliance boils
Excessive level of
non-full cup of water
scale
Large amount of
Water level is below
steam during the boil-
the minimum marking
ing process and the
absence of water in
the cup
Excessive level of
scale
During the boiling
The appliance boils
process the power
the fixed amount of
on/off switch was
water (250 ml). The
pressed, but the pro-
capacity is not ad-
cess of boiling hasn't
justed
stopped
When the tempera-
ture of water reaches
a certain point, wa-
ter is automatically
poured into the cup
The appliance makes
After the boiling pro-
some noise; after boil-
cess is finished you
Solution
Wait a little and try
again
Check the connec-
tion of the appliance
to the mains supply
Check the correct
positioning of the ap-
pliance
Consult service facil-
ity
Let the appliance
cool down, then fill it
with water
De-scale the appli-
ance
Maintain the proper
water level inside the
water container (be-
tween the minimum
and
maximum
marks)
De-scale the appli-
ance
Wait for the boiling
cycle to finish and let
water pour into the
tray for drops. Wait
manually.
for water to cool and
pour it out of the tray
This is normal
11
Publicité
Table des Matières
