Kimpex CLICK N GO 2 Instructions D'assemblage page 7

"CLICK N GO 2" PLOW ATTACHMENT
Kawasaki – Teryx
7) Tighten all bolts and nuts assembled so far with an
appropriate tool.
Assembly of the V-Plate to the Attachment
Plate
8) Assemble four (4) M8-1.25 x 25 mm carriage bolts
and four (4) M8-1.25 hex. nuts
the holes corresponding to the width of the four (4)
slotted holes of the attachment plate
first threads only so as to leave a space between the
head of carriage bolts
9) Assemble one (1) M8-1.25 x 20 mm hex. bolt
one (1) M8-1.25 hex. nut
V-plate . Tighten the bolt with an appropriate tool.
A
C
A
10) Assemble the V-plate
by first aligning the rear carriage bolts
front carriage bolts .
C
A
11) Once the carriage bolts
the slotted holes of the attachment plate
it well using an appropriate tool.
KIMPEX INC. / 5355, rue St-Roch / Drummondville (Québec) Canada / J2B 6V4
KIMPEX USA / 100 Walnut Street / Champlain, New York / 12919
2810521  A-2810521  Printed in Canada
ASSEMBLY INSTRUCTIONS
on the V-plate
D
. Screw the
01
and the V-plate .
C A
and
E
at the front centre of the
D
E
D
on the attachment plate
A
, then the
C
01
inserted to the bottom of
C
, tighten
01
Position of the Push Frame Hook Assembly
Install the push frame hook assembly in Position 2. Refer
to the instructions for the push frame assembly
procedure. It is possible that the position must be
changed to fit the winch installed on the vehicle.
C
in
A
01
374375
KIMPEX NO.
3