Publicité
Step 13
å
Carefully stand your unit upright in its fi nal location. We recommend using the SAFETY STRAP for added stability.
Open the FURNITURE TIPPING RESTRAINT KIT (97) .
å
å
NOTE: Do not turn the SAFETY DRYWALL ANCHOR into a wall stud. If you prefer to fasten the SAFETY
STRAP to a wall stud, go to your local hardware store for proper hardware.
å
INSTALLATION INSTRUCTIONS:
1. Insert the SAFETY DRYWALL ANCHOR through the WASHER and one end of the SAFETY STRAP.
2. Using a Phillips screwdriver or a hand drill, press the screw slightly onto the drywall.
3. Apply pressure; turn the screw until a pilot hole is made and the nylon sheath slips through.
4. Turn the screw until it is fl ush against the wall and you feel a fi rm resistance.
5. Continue to turn until the screw starts spinning freely.
å
Carefully cut out the perforated hole in the BACK (D). Insert the other end of the SAFETY STRAP through this hole, then
use the BLACK 9/16" LARGE HEAD SCREW through the SAFETY STRAP and into the pre-drilled hole in the underside of
the TOP (C2).
å
NOTE: Before moving your unit to a diff erent location, unscrew the SAFETY DRYWALL ANCHOR from your wall. The
nylon sheath will remain behind your wall.
97
www.sauder.com/service
C2
D
420850
Washer
Safety strap
BLACK 9/16" LARGE HEAD SCREW
(1 used in this step)
Safety
drywall
anchor
Page 17
Publicité
