Replacing The Battery - Fujitsu LIFEBOOK T902 Guide D'utilisation

Replacing the Battery

With the purchase of an additional battery, you can have a fully charged spare to swap with one that is not charged.
There are two ways to swap batteries, cold-swapping and hot-swapping:
Cold-swapping Batteries
To cold-swap batteries in your battery bay, follow these easy steps:
Have a charged battery ready to install.
1
Shut down your Tablet PC and disconnect the AC adapter.
2
Turn the system upside down and orient it as shown in Figure 38.
3
While pushing the battery lock towards the battery, slide the batter release latch to the right, then lift the battery
4
out of the bay as in Figure 39.
Insert a new battery into the bay, and press it in firmly so that the latches click into place.
5
Plug in the AC adapter and turn the power on.
6
Hot-swapping Batteries
To hot-swap batteries in your battery bay follow these easy steps:
B
E SURE TO PLUG IN AN
WHILE THE BATTERY IS BEING REPLACED
Plug an AC Adapter into the system and connect it to a power outlet.
1
Follow steps 3 through 6 in "Cold Swapping Batteries".
2
I L
F THE ITHIUM ION BATTERY CONNECTOR IS NOT FULLY SEATED
AC A
DAPTER PRIOR TO REMOVING THE BATTERY
. I
F YOU DO NOT USE AN
73 - Lithium ion Battery
. T
HERE IS NO BRIDGE BATTERY PRESENT TO SUPPORT THE SYSTEM
AC A
DAPTER YOU WILL LOSE ANY UNSAVED FILES
,
YOU MAY NOT BE ABLE TO USE YOUR
.
T PC
ABLET OR CHARGE YOUR BATTERY
.