Hanging The Fan; Attaching The Fan Blades - AirPro P250069 Manuel D'installation

Hanging the Fan

REMEMBER to turn off the power. Follow
the steps below to hang your fan properly:
Step 1. Pass the 120-volt supply wires
through the center hole in the ceiling
hanger bracket as shown in Fig. 5.
Step 2. Secure the hanger bracket to the
ceiling outlet box with the screws and
washers provided with your outlet box.
Washers
Mounting screws
(supplied with
electrical box)
120V Wries
Figure 5

Attaching the Fan Blades

Step 1. Position the fan so that the motor collar is
pointing up as seen in figure 6b. Attach the blade
and washer (d) to the fan motor assembly using blade
up screw as shown in Figure 6b. Repeat this step for
the 2 remaining blades and washers. Tighten the
screws securely.
Step 2. Turn the fan over and position it so that the
motor collar is pointing down. Attach the blade
support plate to the blade assembly using the blade
down screws. (Figure 7)
Step 3. Flip the fan back over so that the motor collar
is pointing up. Attach the motor housing using the
motor housing screws as shown in Figure 8.
Blade up
screw(a)
UL Listed
electrical
box
Ceiling hanger
bracket
Blade
Figure 6
Figure 6b
Washer(d)
Blade
Motor
collar
Blade up screw(a)
Washer(d)
Motor assembly
Blade support plate
Blade down
screw(b)
Blade assembly
Figure 7
Motor housing
Motor
housing
screw(c)
Figure 8
4.