Midea MRU07B3AWW Mode D'emploi page 21

Problem
Door seal fails to be
tight
Water pan overflows
Hot housing
Surface
condensation
Abnormal noise
• Remove foreign matters on the door seal
• Heat the door seal and then cool it for restoration (or blow
it with an electrical drier or use a hot towel for heating)
• There is too much food in the chamber or food stored
contains too much water,resulting in heavy defrosting
• The doors are not closed properly, resulting in frosting due
to entry of air and increased water due to defrosting
• Heat dissipation of the built-in condenser via the housing,
which is normal When housing becomes hot due to high
ambient temperature, storage of too much food or shutdown
of the compressor is shut down, provide sound ventilation to
facilitate heat dissipation
• Condensation on the exterior surface and door seals of the
refrigerator is normal when the ambient humidity is too
high. Just wipe the condensate with a clean towel.
• Buzz: The compressor may produce buzzes during operation,
and the buzzes are loud particularly upon start or stop. This
is normal.
• Creak: Refrigerant flowing inside of the appliance may
produce creak, which is normal.
Possible reason
19