Technical Features; Warranty Certificate - aqua AP EASY Serie Mode D'emploi

CLEANING PROCEDURE DESCRIPTION
Cleaning procedure starts by opening the ball valve at the bottom of the filter. Once opened the discharge
flow creates a vacuum effect that removes the particles from the extrenal surface of the filtering cartridge. By
waiting few seconds the cartridge is automatically cleaned and flushed. Consequently close the bottom valve
completely. The cleaning procedure is now complete and Your AP EASY filter is ready to continue its
standard filter function.
WARNING
Protect the filter from ice, direct sunlight exposition and bad weather; keep it away also from heat sources
higher than 40°C. Avoid the contact of the plastic parts with oils, solvents, acid and basic cleaning products.
To allow a correct washing operation consider a counter pressure of 1,5 bar downstream. The pressure into
the water supply line can't exceed the max. working pressure mentioned on the product's label; It is
recommended to install a water pressure reducer upstream the filter. For a correct filter's maintenance it is
advisable to have it checked twice a year by qualified personnel.

WARRANTY CERTIFICATE

All the articles produced by Aqua are under warranty for a period of 2 years from the date of purchase. The
terms of warranty require that:

The article be used following the instructions printed by the manufacturer, Aqua.

Installation and maintenance be carried out following the instructions of the manufacturer, Aqua.

Goods under warranty may be replaced only upon submission of faulty material and upon verification
of the nature of the defect, which will be considered in light of technical data available from the data-
base in the Aqua engineering department, where the results of daily product testing are recorded.

Warranty is limited to replacement of the faulty part only, to the exclusion of any other claim by the
customer for direct or indirect damages caused by the product.

The customer must pay all labor and transport expenses necessary for replacement of the part
covered by the warranty.
Any warranty on Aqua products be suspended upon failure to comply with the general regulations printed by
the manufacturer, or failure to comply with the relevant European regulations in force.
10/07/13

TECHNICAL FEATURES

L0200170 AP EASY ITA-ING-FRA-SPA
ENGLISH
5/12