Maintenance And Care - D2 RNGWS4000 Instructions D'installation

3. Gently pull on the windshield as per drawing #2 towards the front of the vehicle for the
upper pivot to slide to the end onto the upper pivot cylinder adaptor.
4. Lower the windshield as per drawing #3 and the upper pivot will catch the second upper
pivot cylinder adaptor.
5. Adjust the height of the upper clamp first by ensuring the overall leveling.
6. Tighten all screws regarding the upper pivot.
7. Adjust the height of the clamp to the lower pivot and slide arm and use "T" knob to lock
in place. Drawing #4 shows the position you should have when windshield is closed.
8. Tighten all remaining screws and nuts.
To operate the tilt mechanism:
1. Unlock by loosening both "T" knobs (without removing them).
2. From inside the cab, gently tilt out (both side at the same time) the upper windshield to the
desired position. Note that there are 3 pre-determined positions on the slide arm; closed, half-
opened and fully-extended.
3. Lock in place by tightening back both "T" knobs.
To remove the windshield:
With TWO people, remove both "T" knobs and follow reverse instructions 4, 3 & 2 of step #f).
The tilt mechanism is designed for cooling the airflow in warm temperatures. Note that any open positions
At HIGH SPEED RIDING or when TRANSPORTING the vehicle, the windshield must be CLOSED.
High speed running or trailering with windshield open may cause failure and is not covered by any

2. Maintenance and Care

Tighten all hardware after first use and periodically thereafter.
▪ Rinse with lukewarm water; wash gently with mild soap or detergent and lukewarm water, using a soft cloth or sponge. DO
▪ Rinse again. Dry with soft cloth or moist cellulose sponge to prevent water spotting.
▪ To remove wet paint, glazing compound or grease, rub lightly with a good grade of VM&P naphtha or isopropyl alcohol,
NOTICE: Abusive cleaning procedures by hand washing or automated washing equipment will eventually result in visual
Fantastik
RNGWS4000 - Instructions Polaris Ranger 400 Full Tilt Windshield - rev04
IMPORTANT NOTICES
are designed for LOW-SPEED operation ONLY.
NOT SCRUB or use brushes or squeegees.
then wash and rinse. DO NOT USE GASOLINE.
hazing, loss of light transmission and coating delamination.
Compatible Cleaning Agents
▪
Aqueous Solution of Soaps and Detergents
Joy Formula 409
warranty.
CLEANING:
Mr. Clean Top Job
Drawing #4
VM&P grade Naphtha Hexcel, F.O. 554
www.direction2.com
Drawing #3
Neleco-Placer
4