D2 RNGWS4000 Instructions D'installation

READ AND UNDERSTAND THESE INSTRUCTIONS COMPLETELY BEFORE INSTALLATION TO
AVOID INJURY TO YOURSELF, DAMAGE TO THE VEHICLE OR ACCESSORY.
• Torque specifications must be followed when tightening bolts. Over-tightening any and/or all screws will cause
• As specified on carton label, once protective film on shields is removed, product cannot be returned.
• As specified on carton label, damage caused by packaging staples is not covered by warranty. All staples must be
• Failure to follow these installation instructions completely may void any warrantable components and result in
• Do not use Loctite or any other similar fastener adhesive. These types of products react to plastics and cause
• Our windshields are made from the highest quality material providing optimum transparency and clarity.
Blurriness and/or extrusion marks may or may not appear when looking through windshield from a wide, side-
• The application of improper cleaners, abrasive and/or dirty cleaning towels can severely damage the product.
Failure to follow cleaning recommendation (provided herewith) may void any warrantable components.
These instructions contain important information for future reference and must be given to the customer at time of
ITEM
A
B
C
D
E
F
G
INSTRUCTION BAG
H
I
1. Installation
a) Find a clean flat area where you can safely lay down the lower
windshield (Item B). Partially remove the protective film on both
sides and apply the edge guard (Item C) to the upper lip using manual
pressure to ensure good adhesion to the windshield and cut any
excess. Follow the same procedure for the lower lip.
RNGWS4000 - Instructions Polaris Ranger 400 Full Tilt Windshield - rev04
IMPORTANT NOTICES
• For proper installation, TWO people are required .
cracks around mounting holes which is not covered by any warranty.
removed prior to removing product from carton.
product damage or personal injury.
cracking. Not covered by any warranty.
angle. This is normal for all extruded clear plastic materials.
purchase or upon completion of installation.
Parts List
(parts available with kit only and not available separately)
PART NAME
Upper windshield
Lower windshield
Edge guard strip
Foam cushion
Clamp set (1 ¾" dia.)
Clamp set (1 ¾" dia.)
Nuts & bolts
Top pivot hinge of upper
windshield
Slide arm and lower pivot of
upper windshield
INSTALLATION INSTRUCTIONS
POLARIS RANGER 400
FULL TILT WINDSHIELD
PART # RNGWS4000
DEALER
CNC windshield cut-out made of ¼" thick GE MR10 polycarbonate or equivalent
CNC windshield cut-out made of ¼" thick GE MR10 polycarbonate or equivalent
Includes: 54" edge guard strip [end user to cut to exact length]
Included: 42" of 1" x ⅛" self adhesive foam cushion [end user to cut to exact length]
Includes: 3 male clamp parts and 3 female clamp parts
Includes: 2 male clamp parts and 2 female clamp parts
Includes: 8 socket cap screws M6 x 20, 10 locknuts M6, 18 button head screws M6 x 18, 16
internal lock washers M6, 16 domed shoulder washers M6, 4 button head screws M6 x 45 and
Includes: 2 upper pivots and 4 upper pivot cylinder adaptors
Includes: 2 slide arms 3 positions and 2 lower pivot mounts
DESCRIPTION
2 "T" knobs M6 x 35
Edge guard strip
(+/- 11")
www.direction2.com
QTY
1
1
1
1
2
1
1
1
1
Edge guard strip
(+/- 41 ½")
1