Troubleshooting; Technical Service - Southland SWSTMBA Manuel De L'utilisateur

Operation
(CONTINUED)
• Save all instructions
C
Change Airflow Direction
NOTE: The Wheeled String Trimmer Mower is designed
with the ability to offset the Blower from a centered position
to a right side position.
1. Depress the finger control on the right upper handle.
By depressing the finger control, the head becomes
unlocked and can be swiveled to two positions to the
right. Upon release of the finger control, a pin
will lock the Blower into the desired position. Swiveling
the Blower repositions the outlet and redirects the
airflow forward. (Fig. 5)
2. The airflow can be directed up or down by loosening
the discharge nozzle wing knob and rotating the nozzle
in the desired direction. Tighten wing knob. (Fig. 6)

Troubleshooting

• Save all instructions
PROBLEM
Blower fan will not rotate.

Technical Service

• Save all instructions
You may have further questions about assembling, operating, or maintaining this Blower. If so, you can contact our
Technical Service Department at 1-800-737-2112 (English only). You may also write to:
(Correspondence only)
MAT Engine Technologies, LLC
ATTN: Technical Service – METL
6700 Wildlife Way
Long Grove, IL 60047
When contacting the Technical Service Department, have ready:
• Your Name
• Your Address
• Your Phone Number
• Model Number of Product
• Date of Purchase (include copy of receipt for written requests)
If you need assistance or have any questions,
CALL TOLL FREE: 1-800–737-2112
Questions? Call Toll Free at 1-800-737-2112
POSSIBLE CAUSE(S)
Blower not fully installed into clutch
housing.
EN - 5
FINGER
CONTROL
Fig. 5
SOLUTION(S)
Install Blower so metal saddle on tube is
fully inserted into corresponding opening
of clutch housing.
Copyright © 2018 MAT Engine Technologies, LLC
WING KNOB
Fig. 6