Battery Management - Emist EPIX360 Mode D'emploi

C. FLUID MANAGEMENT:
The system is designed for single or multiple application
environments. Please use the multiple tank applications carefully
by marking tanks with your chemical identifiers when necessary.
Application Tips:
1. While depressing the trigger button, move the applicator in an
"S" pattern from bottom to the top of the surface target area in a
continuous motion.
2. Stay in motion, electrostatically charged droplets will accumulate
in higher levels at the tip of the applicator if you move too slowly
while the device is in use.
3. Do not over apply.
4. In between chemical changes, press the trigger while pointing
to the floor or other safe target area 1-2 minutes to clear the
remaining chemical in the system.
D. BATTERY MANAGEMENT:
Tips:
1. Fully charge each battery before use.
2. Keep battery, charger and all connectors clean and dry at all times.
3. Insert with the battery release button facing upwards into the battery
port.
4. Do not expose batteries, chargers or connectors to liquid.
©2021 EMist® is a registered trademark of SanoTech 360, LLC. All rights reserved.
SPRAY APPLICATION
EMI-018-21 Multilingual Manuals - 040521
EN