Emist EPIX360 Mode D'emploi page 10

EN
Tip: Charge battery first
Step 1: Install Battery into Charger.
y To install, slide battery pack into the charger until the battery pack is firmly
y Once battery is on the charger, a flashing red light indicates the battery is
y Once the battery is fully charged, a solid red light will indicate the batter is
y To remove battery from charger, grasp battery pack firmly, depress battery
y To check charge, press down on the battery indicator light, the light will
Step 2: Liquid Tank Removal:
y To remove the 8oz tank from the spray system hold the tank cap cover and
y This removes the whole tank assembly from the sprayer.
Step 3: Removing the Tank Cap Cover & Cap.
y With the tank removed from the sprayer and holding it vertically, pull the tank
y To remove the tank cap, gently turn the cap counterclockwise until it is fully
Step 4: Installing the Tank Liner:
Tip: When you first receive your sprayer bundle, a tank liner is already
installed in the tank for you. It includes the cap washer which is required
for the liner to sit correctly into the tank itself. The liner is manufactured
to last 100 spray hours or up to 3 months.
y When replacing your tank liner, first remove the used liner from the tank with
y Once removed from the tank, remove the liner from the black cap washer by
y Get new liner, push the black cap washer on by pushing it down around the
y Once the liner is installed with cap washer, fold the liner in an accordion style
Tip: When a new liner is first installed it requires air to be blown into it for
the liner to fully expand. By doing this the liner becomes fully inflated for
all 8oz of fluid to fill the tank.
©2021 EMist® is a registered trademark of SanoTech 360, LLC. All rights reserved.
EMI-018-21 Multilingual Manuals - 040521
ASSEMBLY & OPERATING INSTRUCTIONS
1. Plug charger cord into wall outlet.
2. Install battery into charger.
3. Reference power indicator (3 bars = full charge)
seated. It will click into the slot.- Note: Some chargers might require more
force on first seat.
charging.
fully charged.
- Tip: A fast blinking light on the charger indicates battery pack is not seated
correctly.
pack button down, and slide out from the charger.
illuminate 3 green bars when battery is fully charged.
the tank while gently pulling up the front of the tank from the spray system to
remove it from the tank lock. Then pull up on the back to remove it from the
tank back clip.
cap cover straight up. No twisting is required.
removed from the tank.
the black cap washer by firmly holding the tank.
holding the liner firmly in one hand, and pushing upwards on the washer to
remove it from the liner threads.
spout of the liner. Push the cap washer until the top of the liner spout and
washer are flush with each other.
and slide it into the tank until the cap washer is flush with the tank opening.