Publicité
T-Connector Wiring Kit
INSTALLATION INSTRUCTIONS
1. Read instructions thoroughly before beginning.
2. Locate the vehicles tail light wiring harness behind the
rear bumper. The harness will be
located along the inside of the left
(drivers) side frame rail and will
have connectors similar to those
on the T-Connector
harness (Fig. 1).
3. Separate the vehicle
connectors, taking care not to damage the locking tabs.
Inspect the connectors for dirt & debris and clean if necessary.
4. Position the T-Connector harness between the separated
vehicle harness connectors. Press the T-Connector ends firmly
into the vehicle harness connectors until they lock into place.
Take care not to damage the locking tabs.
5. Locate a clean accessible mounting location on the vehicle
near the wiring harness ends within reach of the white wire
and grounding eyelet and drill a 7/64" hole.
Caution: Take care not to drill through the body or
any exposed surface.
Mount the white wire using the ground screw and eyelet
provided.
6. Confirm correct operation with a test light or by using a
trailer.
Fig. 1
Publicité
