Poe Rules; Poe Max - Atlantis NetMaster F8PoE Mode D'emploi

Ethernet Ports (5-8)
DC Power Jack

5. PoE Rules

5.1 PoE Max

This function will help to protect the POE Switch and to stabilize the power
transmitting to the powered device (PD).
If the system power remain <= 7.5 watt, the POE MAX LED will light on and the
system will not provide power to the additional POE PD to protect the POE Switch
itself and to stabilize the power transmitting to the former POE PD plugged in the
Switch.
For example, when there are POE PD were connected to the POE Switch and the
total power consumption spends 25 watt, at this time the system remain 5 watt for
buffer and the POE MAX LED will light up. Once there is another POE PD inserted,
the system will not provide power to the additional POE PD.
These ports support network speeds of either 10Mbps
or 100Mbps, and can operate in half- and full- duplex
transfer modes. These ports also supports automatic
MDI/MDIX crossover detection function gives true
"plug and play" capability, just need to plug-in the
network cable to the hub directly and don't care if the
end node is NIC (Network Interface Card) or switch
and hub.
These ports support network speeds of either 10Mbps
or 100Mbps, and can operate in half- and full- duplex
transfer modes. These ports also supports automatic
MDI/MDIX crossover detection function gives true
"plug and play" capability, just need to plug-in the
network cable to the hub directly and don't care if the
end node is NIC (Network Interface Card) or switch
and hub.
Power is supplied through an external DC power
adapter. Check the technical specification section for
information about the DC power input voltage.
Since the switch does not include a power switch,
plugging its power adapter into a power outlet will
immediately power it on.
28