Tips For Use; Cleaning, Care & Maintenance; Auto Defrost - NISBETS ESSENTIALS DB303 Mode D'emploi

Tips for use:

• Avoid opening the door too often. Opening the
door for long periods can cause a significant
increase of the temperature in the appliance.
• If the gasket or door seal is damaged or
deformed, energy consumption will increase. To
restore efficiency, replace in time.
• If the appliance is left empty for long periods,
switch it off. Then defrost and clean it thoroughly.
Let it dry well and leave the door open to prevent
mould developing within the appliance.
• Clean regularly surfaces that can come in contact
with food and accessible drainage system.
• Condensation will form in refrigeration with
frequent opening of the doors and on hot humid
days, please ensure condensation is allowed to
drain properly or is wiped dry.
Cleaning, Care &
Maintenance
Troubleshooting
A qualified technician must carry out repairs if required.
Fault
The appliance is not The unit is not switched on
working
Plug or lead is damaged
Fuse in the plug has blown
Mains power supply fault
Appliance is noisy or Appliance is not level
works intermittently
The appliance is touching a
neighbouring object
Cooler cabinet is not Temperature set incorrectly
cold enough
External environment may
require colder temperature
The door is opened too often Only open when necessary
Door seal is worn
The light does not Bulb has blown
work
Door will not close Cooler is not level
properly
Door has been reversed and
not properly fitted
Shelves are out of position
Door seal is dirty
DB303_ML_A5_v2_20221206.indb 5 DB303_ML_A5_v2_20221206.indb 5
•
•
•
•
•
•

Auto Defrost

Periodically the appliance will run an automatic
defrost cycle to prevent any ice build-up.
Note: In case of Ice built-up (3-5mm thick), set the
thermostat to "O" and leave the door open. Then
manually defrost the appliance. Never use sharp
objects for scraping.
Probable Cause
Check the unit is plugged in correctly and switched on
Replace plug or lead
Replace the fuse
Check mains power supply
Adjust the feet to level the appliance
Check installation position and change if necessary
Check temperature and reset if necessary
Check temperature and reset if necessary
Replace the seal
Consult a qualified technician
Adjust the feet
See "Reverse the door"
Check all shelves are properly inserted
Wipe clean with a damp cloth
Switch off and disconnect from the power supply
before cleaning.
Clean the interior of the appliance as often as
possible.
Do not use abrasive cleaning agents. These can
leave harmful residues.
Clean the door seal with water only.
Always wipe dry after cleaning.
If left unused for any length of time, store the
appliance with the door ajar.
Solution
EN
5
2022/12/6 10:16 2022/12/6 10:16