Reverse The Door - NISBETS ESSENTIALS DB303 Mode D'emploi

EN
Installation
Location: Not for use in vans or trailers, food
trucks or similar vehicles.
Note: If the unit has not been stored or moved
in an upright position, let it stand upright for
approximately 12 hours before operation. If in
doubt allow to stand.
1. Remove the appliance from the packaging and
the protective film from all surfaces.
2. Avoid positioning the cooler in direct sunlight or
damp areas.
3. To optimize performance and longevity, ensure
a minimum clearance of 2.5cm is maintained
between the unit and walls and other objects,
with a minimum 20cm clearance on the top.
NEVER LOCATE NEXT TO A HEAT SOURCE.
4. If necessary, adjust the screw legs of the cooler
to make it level.
Note: Before using the appliance for the first
time, clean the shelves and interior with soapy
water then dry well.

Reverse the Door

Before action, ensure to disconnect the appliance
from the power supply.
The door is opened from left side originally.
1. Remove the hinge cover and the upper hinge
from the right top (Fig. 1A). Then remove the
door.
2. Remove the screw covers from the left top and
install on the right top (Fig. 1B).
1
B
3. Remove the screw cover from the left top of the
door and install on the right top (Fig. 2).
4
DB303_ML_A5_v2_20221206.indb 4 DB303_ML_A5_v2_20221206.indb 4
4. Remove the lower hinge from the right bottom
5. Install the door onto the lower hinge. Then install
6. Now the door is opened from right.
Operation
A
Thermostat
Located at the rear of the
cabinet, the thermostat is
graded from MIN (9°C) to
MED (5°C) to MAX (1°C).
Note: For best results and optimum efficiency, we
recommend setting the controller to MED.
Note: Setting the thermostat to 'O' turns off the
compressor.
Turn on
1. Close the door of the appliance.
2. Connect the appliance to a mains power supply.
3. Turn the light switch On (I) or Off (O) as desired.
2
and install on the left bottom (Fig. 3).
3
the upper hinge on the left top. Note: Before
tightening the screws, ensure the top of the
door is level with the top of the cabinet and the
rubber gasket makes a good seal. Finally install
the hinge cover.
2022/12/6 10:16 2022/12/6 10:16