Installation; Hints And Troubleshooting - SUNTERRA 200450 Guide Du Propriétaire

[ 03
ENGLISH

INSTALLATION

How to Install: Place your pump on top of a flat brick or stone at the bottom of your
water garden. Elevating the pump off of the basin bottom will help prevent debris from
interfering with the pump's performance.To test performance, completely submerge
the pump under water and plug into a GFCI outlet.When your pump is working
properly, you will hear a low humming sound and water will be circulating out of
the top outlet. If you do not hear the humming sound or experience performance
problems, please read the troubleshooting tips and care instructions in this guide.
Note:When attaching an adapter, fountain nozzle or other accessory to the pump, use
plumber's tape at the connection points for a tight fit.

HINTS AND TROUBLESHOOTING

Pump operates but there is no water flow
CAUTION: ALWAYS UNPLUG THE PUMP BEFORE HANDLING.
Make sure the pump is fully submerged. Check the tubing for kinks or obstructions and
ensure pump outlet is clear of objects. If normal water flow has not returned, remove
the cover, filter and plate (or inlet cover) to access the impeller area.Turn the rotor to
ensure it is not broken or jammed. Rinse the impeller and rotor assembly with clean
water to remove any debris. Clean the filter in clean water and replace cover, filter
and plate (or inlet cover) before plugging into GFCI outlet.
SUNTERRA, L.L.C. 1.866.866.4486 www.sunterrausa.com