Sauder 415543 Instructions D'assemblage page 6

2 2
Notch
Straight edge
MM
Finished edge
NOTE: Before beginning this step, separate the SLIDES from the SLIDE SETS (MM) and the DRAWER PINS at the end of the
SLIDES using a SCISSORS. Save the DRAWER PINS. You will use them in Step 10.
Fasten the SLIDES (MM) to the ENDS (FF and GG). Use four SILVER 3/4" PAN HEAD SCREWS (52S) through the first and last
holes in the SLIDES.
NOTE: The SLIDES are marked "RIGHT" and "LEFT" for easy identification. The SLIDE marked "RIGHT" will fasten to the
RIGHT END (FF) and the SLIDE marked "LEFT" will fasten to the LEFT END (GG). There are also arrows on the SLIDES for
correct positioning on the ENDS.
Page 6
DRAWER PIN
(Save for Step 10)
Angled edge
LEFT SLIDE
GG
www.sauder.com/services
MM
Using your Scissors, separate the
SLIDES and the DRAWER PINS
RIGHT SLIDE
MM
FF
SILVER 3/4" PAN HEAD SCREW
(4 used in this step)
Finished edge
52S
415543