HQ Power VDPDMXPC12 Mode D'emploi page 2

3. General Guidelines
• This device is a lighting controller for professional use on stage, in discos, theatres, etc. The
VDPDMXPC12 should only be used indoors with an alternating current of max.
230Vac/50Hz.
• Do not shake the device. Avoid brute force when installing or operating the device.
• Select a location where the device will be protected against extreme heat, moisture and dust.
Respect a min. distance of 50cm between the projector's light output and the illuminated
surface.
• Do not use or transport the device under temperatures < 5°C or > 35°C.
• Familiarise yourself with the functions of the device before actually using it. Do not permit
operation by unqualified people. Any damage that may occur will probably be due to
unprofessional use of the device.
• Use the original packaging if the device is to be transported.
• There may be some smoke or a particular smell when the device is activated for the first
time. This is normal and any smoke or smell will gradually disappear.
• Do not touch the device during use as the housing heats up.
• Note that all modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may cause short circuits, burns,
electroshocks, lamp explosions, crashes, etc. Using the device in an unauthorised way will
void the warranty.
• Do not stand directly below the device when mounting, removing or repairing it. Have a
qualified technician check the installation once a year and once before you bring the device
into service.
4. Installation
CAUTION : Make sure there are no inflammables within a radius of 50cm when you are
mounting the device. The electric connection should be executed by a qualified
technician.
• Do not operate the device unless the cover is in place.
• Only replace a fuse when the device is not connected to the mains. Use a fuse of the same
type. Unscrew the fuse holder on the front panel, replace the old fuse and insert the fuse
holder in the housing again.
• Connect the controller to the mains with the power plug. An ON/OFF switch with a min.
clearance of 3mm at every pole has to be included in the permanent electrical installation if
the device is to be directly connected to the local power supply network.
5. Description
a) Front Panel
1. Power ON indicator
2. Output fuses
3. Output indicators
4. UP button
5. DOWN button
6. MODE button
7. LED display
VDPDMXPC12 2 VELLEMAN