Table des Matières
Publicité
2.2 WIRELESS REMOTE CONTROL
Arm button
Home mode button(Stay)
The remote control requires a CR2025 battery to be operated.
2.2.1 Arm control panel
Press Arm button to enable the alarm panel, the LED indicator lights on (siren hoots
once) and the system enters Arm state.
If there comes an intruder, the siren will hoot to deter the intruder
Note: The siren turns off after ringing for 5 minutes as default setting
At the same time, the system dials the pre-stored phone numbers automatically.
2.2.2 Disarm Control Panel
Press Disarm button to disable the alarm panel, the LED indicator blacks out (siren
hoots twice) and the system is disarmed.
5
LED indicator
Disarm button
Panic button (SOS)
When intruders are detected, siren will keep hooting. If you press Disarm button,
siren will stop hooting but the last corresponding zone LED indicator on the panel still
flashes for checking.
Press Disarm button again, all zone indicators black out.
2.2.3 Home Mode
Home mode consist to maintain your entire home under the alarm control and to
keep a room free of movement.
For example:
BCDE areas of your living home space are subject to be monitored by the control
panel except the area A. This means that you can move freely in the area A except
BCDE.
2.2.4 Mute Mode
Press Home button on the remote control, then press Arm or Disarm button, the
siren keeps silent to finish the operation. The system is armed or disarmed in mute
without disturbing other people.
2.2.5 Emergency Call
No matter what state the control panel is in, once SOS button on the remote control
is pressed, the system immediately goes into emergent alarming state.
SOS
6
Publicité
Table des Matières
