Publicité
Fig.
3/
3
3-A
Togliere le protezioni in plastica ed inserire la piastra 3-B. Posizionare l'anello in teflon
ed avvitare la maniglia
Remove the plastic protections and insert plate 3-B. Position Teflon ring
3-C
handle
on the cartridge rod.
Retirer les protections plastiques et insérer la plaque 3-B. Positionner l'anneau de téflon
et visser la poignée
Quitar las protecciones de plástico e introducir la placa 3-B. Colocar el anillo de teflón
enroscar el mando
Tire as protecções de plástico e insira a placa 3-B. Posicione o anel de teflon
3-C
a pega
no haste cartucho.
IMPORTANT
Pressure & Temperature Requirements.
•
Hot and cold water inlet pressures should
be equal.
•
Inlet pressure range: 150-1000 kPa
•
New Regulation: -500 kPa maximum operating
pressure at any outlet within a building.
(Ref. AS/NZS 3500.1-2003, Clause 3.3.4)
•
Maximum hot water temperature: 80°C.
3-C
sull'asta cartuccia.
3-C
sur la tige de la cartouche.
3-C
en la varilla del grifo.
3-B
3-C
3-A
3-A
IB RUBINETTERIE s.p.a.
via dei Pianotti 3/5
25068 Sarezzo (BS)
phone +39 030 802101
fax +39 030 803097
ibrubinetterie@ibrubinetterie.it
www.ibrubinetterie.it
3-A
and screw
3-A
3-A
y
e aparafuse
Publicité
