Installation Instructions - Cequent Cargo Tray 1394580 Mode D'emploi

Tools required for assembly: 7/16" Wrench, 7/16" Socket, 9/16" Wrench
Step 1: Remove all parts from box and make sure all parts out of the box are undamaged.
Step 2: Assemble Cargo Tray
A. Align both halves of the basket on the ground. Attach each end plate to the outside of the basket as
shown in Fig 1 and fasten loosely with (12) 1/4" bolts, (24) 1/4" flat washers, and (12) 1/4" hex nuts.
B. Slide 2" shank through shank hole and align holes in end plates. Align center plate on the inside of the
basket with holes in shank and loosely attach with (2) 3/8" carriage bolts, (2) 3/8" flat washers, and (2)
3/8" nuts.
C. Go back and tighten all hardware. Tighten all 1/4" hex bolts to 6 ft‐lb and all 3/8" bolts to 24 ft‐lb.
M
I
Step 3: Install Cargo Tray to Hitch
A. For 2" hitches, slide Cargo Tray shank into hitch so that hitch holes and shank holes are aligned. Insert
5/8" hitch pin through hole and secure with clip. (Fig 3)
Installation Instructions
C
E A
E
J
Fig 1
Tie Down holes (12 total)
Optional license
plate/light Kit Mounting holes
Apply reflective tape to corners
Mesh removed
for clarity
B
Fig 3
D
F
K
Fig 2
G
H
L