JessEm MAST-R-FENCE III Guide De L'utilisateur page 9

Step 5: Levelling the tracks to the table top
14 29 18
14 29
Figure 5
NOTE: The Tracks of the Mast-R-
Fence III are slotted to allow for
vertical adjustment to ensure the
fence tracks are perfectly flush with
the table top.
Step 6: Mounting your fence to the tracks
7 7
Figure 6
5
5
4
4
6
6
3
3
7
7
Figure 7
a.
Turn your top right side up on the 2" spacers or you can now
mount the top to a stand.
b.
Place the fence on the table top in its upright position and allow
it to hang over the table edge and lie across the front end of
the fence track.
c.
Loosen the (3)
Raise the fence track so that it is flush with the bottom of the
fence. See figure 5.
18
d.
With the
e.
Move the fence to the back of the table and use it to position
the rear end of the track in the same way, then tighten the rear
screw.
f.
Tighten the centre screw to complete the leveling of the fence
track. Repeat step 5 to level the fence track on the other side
of the table.
g.
Check that the tracks are flush with the table top and readjust
a.
Slide the ¾" x 2-
clamping knob into the T-slot. See Figure 6. Slide the clamping
T-nut into the T-slot until the threaded hole aligns with the hole
in the knob mount (part #7). Repeat this step for the other side
of the fence.
36
36
18
18
a.
Loosen the (4) #10-24 X ½" pan head torx screws (part #3) so
that the knob mounts (part #7) can slide.
b.
Slide the clamping knob washers (part #4) onto the clamping
knob studs (part #6).
c.
Tighten the clamping knobs into the clamping knob T-nuts (part
#36).
d.
Once the fence is centred and the clamping knobs are tight;
tighten the (4) #10-24 X ½" pan head torx screws (part #3).
Repeat step 6 for both sides of the fence.
⁄ "-20 x ⁄ " socket head cap screws (part #29).
1 5
4 8
⁄ " hex key provided, tighten the front screw.
3
16
⁄ " rectangular T-nut (part # 36) for the track
1
2
9