Publicité
Les langues disponibles
Les langues disponibles
Step 4:
Installing hex nuts
C
C
22
22
22
22
Figure 4
NOTE: DO NOT tighten the #10-24 X ½" torx screws (part B) until after the
micro adjuster is mounted.
a.
Slide (1) of the #10-24 hex nuts (part
#22) into the slot of your TA Fence.
b.
Slide the previously removed clamp-
ing knob mounting block (part C)
with attached hex nuts back into the
slot of the TA Fence.
c.
Slide the other hex nut (part #22)
into the slot of the TA Fence. See
figure 4.
6
Publicité
