JessEm Micro Adjuster Guide De L'utilisateur page 5

THE FOLLOWING INSTRUCTIONS ARE FOR MOUNTING THE
#04550 MICRO ADJUSTER TO A JESSEM TA FENCE
Step 3: Removing the clamping knob
A
A
B
B
C
C
Figure 3
NOTE: Be sure NOT to lose the (2) hex nuts mounted in the slot of the
TA Fence.
a. Remove the clamping knob (part A)
from your TA Fence. HINT: Loosen
then pull straight up to remove.
b. Loosen the (2) #10-24 X ½" torx
screws (part B) so the clamping
knob mounting block (part C) can
be removed from the TA Fence.
5