Publicité
6 6
18"
Carefully turn your unit over onto its front edges. Unfold the BACK (F) and lay it over your unit.
Make equal margins along all four edges of the BACK (F). Push on opposite corners of your unit if needed to make it "square".
Fasten the BACK (F) to your unit using the NAILS (Y). The NAILS should be 5" apart and 1/4" in from the edges.
Find and mark the center of the SHELF (E) on the BACK by measuring 14-3/8" from the TOP (C). Using a straight-edge, line it up
with the pencil marks, then draw a straight line across the BACK. Tap NAILS along this line.
Repeat marking a line on the BACK for the UPRIGHT (C) by marking a line 18" from the LEFT END (B).
Page 10
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Draw these lines to nail on.
F
www.sauder.com/services
14-3/8"
B
5"
1/4"
Y
NAIL
(59 used in this step)
1-1/2"
413329
Publicité
