Télécharger Imprimer la page

MaxxMar SUNSET SHADES Instructions D'installation

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

1. Mount the brackets to the wall or window frame, with the outside brackets no further than 2 inches (50 mm) from the ends of the headraill. On wide
shades, space the additional bracket(s) at equal intervals
It should be assembled brackets
(on the side of control clutch) in
distance as showed here)
100 mm
20 mm
In case head clutch is assembled here.
2. Install the Tension Device. The Tension Device reduces the
hazards of strangulation and entanglement of the young children by
limiting access to the window frame or wall, so that young children
cannot pull the cord around their necks.
A. Lower the blind.
B.Hold the Tension Device upright so the Warning Tag hangs
straight down as shown in the diagram.
C.Position the Tension Device on the window frame or the wall so
that the Tension Device and control cord do no interfere with raising
or lowering the blind. The Tension Device should be installed
without stretching or pulling down on the control cord. Stretching
the cord will cause excessive wear. Do not twist or cross the control
cord.
D.Holding the Tension Device upright and in position, as shown,
insert and secure the screw through the hole. The mounting screw
must be secured into a solid surface or molly.
3. Operate the shade by pulling down on one side of the cord – one
side of the cord raises the shade, the other side lowers the shade.
Do not lift the bottom rail with your hands. Also, be careful not place
objects on the window sill that will interfere with operating the shade
or cause it to hang unevenly.
For more safety information: 1-866-662-0666 • www.healthcanada.gc.ca/blindcords
.
450-550 mm
Installation Instruction
80 mm
450-550 mm
CS -7
Minimum
bracket depth
for inside
mount 1 3/4"
S H A D E S
In case end pin is
assembled here, it
should be 80 mm
distance.
Spring loaded Ceiling and
wall bracket
For wall or outside mounts,
use the rear bracket holes.
Sunset Cassette
with universal ceiling or wall bracket
2 3/4"
3 1/4"
For wall
mount.
Universal ceiling or wall mount bracket
Shades over 60" in width please
use 3 brackets.
For ceiling
mount.
2 3/4"

Publicité

loading

Sommaire des Matières pour MaxxMar SUNSET SHADES

  • Page 1 ™ S H A D E S Installation Instruction 1. Mount the brackets to the wall or window frame, with the outside brackets no further than 2 inches (50 mm) from the ends of the headraill. On wide shades, space the additional bracket(s) at equal intervals In case end pin is 80 mm assembled here, it...
  • Page 2 Instructions d’installation ™ S H A D E S 1. Fixer les supports contre le mur ou le cadre de fenêtre, en plaçant les supports extérieurs à pas plus de 2 po (50 mm) des extrémités du caisson supérieur. Sur les stores qui sont plus larges, espacer les autres supports uniformément. Au cas où...