Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
❸
❺
❼
4 screws
(M4x10 mm)
0. Place the tower fan on a slightly elevated
0. Place the tower fan on a slightly elevated surface so the bottom end protrudes
surface so the bottom end protrudes slightly to
slightly to fasten the foot. If necessary, place a sheet or blanket beneath the product to
fasten the foot. If necessary, place a sheet or
protect the surface.
blanket beneath the product to protect the
surface.
1. To assemble the stand, simply snap the two halves (B & C) together (Fig. 1).
1. To assemble the stand, simply snap the two
2. Pull the power cord through the assembled stand, making sure the wider end of the
halves (B & C) together (Fig. 1).
stand is facing towards the fan housing (Fig. 2).
2. Pull the power cord through the assembled
stand, making sure the wider end of the stand is
3. Align the hole "A" located at the bottom of the fan housing with the post "A" on the
facing towards the fan housing (Fig. 2).
top end of the stand. Insert the post into the hole (Fig. 3).
3. Align the hole "A" located at the bottom of the
4. Secure the stand to the fan housing with 4 screws (M4x10 mm). Tighten the screws
fan housing with the post "A" on the top end of
with a screwdriver (Fig. 4).
the stand. Insert the post into the hole (Fig. 3).
4. Secure the stand to the fan housing with 4 screws
5. Feed the power cable through the middle of the foot and then stick the foot
together. Make sure the flat side is down. Snap the two base halves (E & F) together by
13
www. De uba 2 4 o n lin e . de
sliding the posts of one base half into the slots of the second base half (Fig. 5).
❹
Hole "A"
Post "A"
❻
❽
(M4x10 mm). Tighten the screws with a
screwdriver (Fig. 4).
5. Feed the power cable through the middle of
the foot and then stick the foot together. Make
sure the flat side is down. Snap the two base
halves (E & F) together by sliding the posts of one
base half into the slots of the second base half
(Fig. 5).
6. Pull the power cable through the central hole
of the already assembled base plate. Align the
post "B" located at the bottom of the stand with
the hole "B" located on the central hole. Then
insert the posts into the holes (Fig.6).
7. Secure the base plate to the stand by 4 screws
4 screws
(M4x10 mm)
Post "B"
Hole "B"
www.DeubaXXL.de
15
Publicité
Table des Matières
