Publicité
General information:
The outdoor fireplace/garden grill has to be
assembled on compacted, leveled ground or
concrete. Make sure there is sufficient clea-
rance (36 inches), between the unit and flam-
mable material. Step #4: the refractor base is
an option when grilling (can be omitted), but
is mandatory for wood burning.
Using the outdoor fireplace/garden grill:
Start the fire with a small flame; if unit is ex-
posed to extreme heat too quickly, cracking of
the parts might occur. This is very important
if the weather condition caused the concrete
parts to become wet. However, if cracks should
occur, it would not dimish the function of your
outdoor fireplace/garden grill, because all com-
ponents are metal re-enforced. The occurrence
of hairline cracks in the refractor parts are pos-
sible, but do not constitute a claim.
Recommended burning materials:
The outdoor fireplace/garden grill is made
for usage of charcoal only!
Do not use more than 10 lbs of charcoal at
one time!
Use only recommended starter fluid or kind-
ling!
Do not use kerosene or gasoline, or similar
liquids to light the charcoal/firewood!
Attention:
Do not overheat the outdoor fireplace/garden
grill!
Assembly:
Make sure the ground is prepared and the base
is leveled. Follow the drawing to assemble
�
part
-
. Make sure the space between the
�
�
�
refractor hood
and the outer hood
all around. This ensures even air circulation bet-
ween the two parts.
It is important, that all components are assem-
bled flush at the rear, except the outer hood
�
, which should have an overhang of app.
3/4 inch.
It is recommended to "spot glue" all parts, but it
is mandatory to glue all parts completely toge-
ther from the top of the outer hood up. Drying
time for the adhesive is app. 24 hours.
The optional spark arrestor (USA only) has
to be glued between the two-piece chimney
extension.
Included:
1 bag of adhesive.
Disassembly:
If unit has to be disassembled, follow the re-
versed instructions.
Cleaning:
The surface of your outdoor fireplace/garden
grill can be cleaned with either a high pressure
power washer, or diluted bleach and coarse
brush.
The copper inlay (on some models), will show
a green patina after a period of time, which is
normal, but can be cleaned with copper or brass
cleaning material, if so desired.
English
�
is equal
Publicité
