ABC Design Zoom Carry Cot Instructions De Service page 5

1. Opening the carrycot
Lift the side panels of the carrier.
Extend and secure the side panels by pushing the two retainers outwards into the mountings.
Make sure that the retainers are securely engaged.
2. Attaching the cot bumper
Lay the bumper in the cot, folding the top part over the edge of the carrycot.
Fasten the four press studs on the rear.
3. Attaching the hood to the cot bumper
Fasten the four press studs on the bottom of the hood onto the bumper.
4. Fitting the adapter to the carrycot
Fit the adapter onto the carrycot from below until it engages in the brackets provided.
Make sure that the adapter is securely engaged.
5. Inserting the mattress
Insert the mattress in the cover.
Lay the mattress on the base.
NB: The mattress is wedge-shaped. Make sure that the raised part is at the head end.
6. Adjusting the handle
To adjust the handle, press the buttons on both sides.
Now you can adjust the handle.
EN - 06
7. Fitting the apron
Fit the closed end of the apron over the lower end of the carrycot.
Extend the apron over the cot.
Secure the ends of the apron with the Velcro fastening provided on the
outside of the hood.
1
8. Mounting the carrycot on the pushchair
The adapter is fitted to the long side of the carrycot.
Place the carrycot onto the pushchair so that the catch mechanism
engages.
To remove the carrycot, press the buttons on the adapter on both sides
2
of the cot and lift the cot up to release it from the catches.
CAUTION: Always check before use that the carrycot is correctly
secured to the pushchair.
3
4
5
6
7
8
8
EN - 07