Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
SETUP
• Prior to each use, visual inspection (See Pg.2) shall be made to the device by checking for
abnormal conditions, such as cracked welds, damaged, loose or missing parts.
• Consult the vehicle owner's manual to determine the location of support points.
• Be sure to set the vehicle in park with the emergency brake on and wheels securely chocked.
• Be sure that the vehicle and the jack stands are on a hard, level surface.
ASSEMBLY
• Insert ratchet bar into collar.
• Lift ratchet bar upward to ensure the ratchet and locking pawl positively engage at each and
every position.
• To lower, lift the handle, disengage the locking pawl from the ratchet bar and slowly move the
ratchet bar down.
• Use a hammer and punch to bend the locking tab inward (3 & 6 Ton). This will prevent the
ratchet bar from accidentally coming loose.
• For 12 Ton jack stands, tighten the provided hex bolt into the collar to prevent the loss of the
ratchet bar (See bottom of page for details).
OPERATION
1. For correct stability choose a hard and flat surface.
2. Engage the hand brake and put the vehicle into gear.
3. Adjust the ratchet bar to the desired height, and lock it with the locking handle.
4. Secure the jack stand with the safety pin.
5. Jack up your vehicle as specified by the manufacturer.
6. Centre the load over the saddle of the jack stand. It is advisable to leave the jack in place
when the weight of the vehicle is supported by the jack stand.
7. To remove the jack stand, jack the vehicle up again, pull the jack stand free, then lower the
vehicle to the ground.
8. Protect the jack stands from corrosion by cleaning
them thoroughly. Do not apply oils or lubricants to any
portion of this product
MAINTENANCE
Inspect each stand before use. Ensure all parts move
freely. Only apply grease to the locking handle pivot
point of this product and ensure all excess grease is
wiped away before stand is used. If rust appears, sand
away the rust area and cover with appropriate utility
paint. Please note that there are no replacement parts
available for this product.
Tab
Safety
Pin
Base
Ratchet
Bar
Collar
Locking
Handle
3
USER MANUAL
Publicité
Table des Matières
