Yamaha SPS-3000 Mode D'emploi

Speaker Stand
Support d'enceinte
This product is a general household speaker stand developed for use with NS-3000.
Plate
629 mm
Column
(24-3/4")
401 mm
(15-3/4")
44.5 mm
(1-3/4")
Base
306 mm
(12")
Accessories
Before assembling the speaker stand, make sure that all accessories are included.
1 2
Screw × 2 Spike × 4
When setting up this speaker stand on a thick carpet,
etc., installing the spikes can improve the sound
quality and prevent wobbling.
Refer to "Using the speaker stand with spikes (2)".
NOTE
• Since pads are attached to the bottom of the speaker
Pad stand, it can be used without installing the spikes.
Bottom side
of the Base
WARNING
• To prevent accidental ingestion, keep spikes that are not used out of the reach of children.
Setup
Follow the procedure below to install speaker NS-3000 onto this speaker stand.
NOTE
• This speaker stand can be used facing either forward or backward.
• When installing the speaker, also refer to its Owner's Manual.
1.
Place the speaker stand at the setup location.
CAUTION
• Be sure to place this speaker stand on a level and stable floor surface. Otherwise, it may
tip over, causing injuries.
• Remove the speaker from the speaker stand before moving them. Two people should grip
the column to move the speaker stand.
3.
Align the screw holes in the bottom of the speaker with the holes in the
plate, and then insert the screws into the screw holes from the bottom of
the plate and tighten them.
1
CAUTION
• Be careful not to trip over the speaker cables. Otherwise, the speaker stand may tip over,
causing injuries.
NOTICE
• Be sure to use the included screws to prevent the speaker from falling off.
• While mounting the speaker onto the speaker stand, hold the speaker to prevent it from
falling off.
• Due to the material characteristics, the wood of the NS-3000 will shrink. In addition, the
screws may become loose due to vibrations caused by music playback. If that occurs,
retighten the screws.
• When installing/removing the speaker, do not drag the speaker along the top of the speaker
stand. Otherwise, the bottom of the speaker or top of the plate may be scratched or peeled off.
• Do not overtighten the screws. Otherwise, the speaker stand or speaker may become
damaged or deformed.
Owner's Manual
Mode d'emploi
 Specifications
Dimensions (W × H × D)
..............................306 × 629 × 401 mm
(12" × 24-3/4" × 15-3/4")
(Not including the height of supplied spikes)
Weight...................... 15.3 kg (33.7 lbs.)
* The contents of this manual apply to
the latest specifications as of the
Plate
publishing date. To obtain the latest
manual, access the Yamaha website
then download the manual file.
Using the speaker stand with spikes (2)
1.
Spread out blankets or soft cloths on a level surface, and then lay the
speaker stand on its side.
2.
Screw the spikes into the holes provided in the base.
CAUTION
• Be careful since loosening the spikes too much may cause them to fall off.
• Tilting the speaker stand to set it up requires two or more people so that it does not tip over.
NOTE
• Allowing the tips of the spikes to drag may scratch the floor. Be careful when installing the
speaker or moving the speaker stand.
• When the spikes are installed, be careful not to scratch the floor.
• Due to the weight of the speaker stand and speaker, marks may be left on the floor or carpet.
2.
Place the speaker on the plate of the speaker stand.
• When placing the speaker on this speaker stand, be sure not to pinch your fingers.
Otherwise, injuries may result.
NOTE
• Before performing operations, disconnect the speaker cables from the speakers.
• For details on the locations of the screw holes in the bottom of speaker NS-3000, refer to its
Owner's Manual.
y When using the speaker stand with spikes
After installing the 4 spikes, place the speaker stand at the setup location.
If the speaker stand is wobbling, turn the spikes and adjust them so the speaker stand does not wobble.
1
CAUTION
• When adjusting the spikes while tilting the speaker stand, support the speaker stand and
speaker by two or more people. Falling or toppling may result in injury or damage.
EN FR
English
Français
Published 04/2020 IPEI-A0
CAUTION
• The speaker stand should be set up or moved by
two or more people. Otherwise, the speaker
stand may fall or tip over, causing injuries.
NOTICE
• First spread out blankets or soft cloths to prevent
the floor from being scratched.
NOTE
Base
This speaker stand is made with wooden parts.
Screws may become loose due to expansion/
contraction of the wood caused by environmental
changes or due to vibration during use. If that occurs,
retighten the screws with a Phillips screwdriver.
Screws (6 locations each)
CAUTION
PRECAUTIONS
PLEASE READ CAREFULLY BEFORE USE. BE SURE TO FOLLOW THESE
INSTRUCTIONS.
The precautions listed below are to prevent risk of harm to the user and others, as well as to
prevent property damage, and to help the user use this unit properly and safely. Be sure to
G
VAG3280
follow these instructions.
After reading this manual, be sure to keep it in a safe place where it can be referenced at any time.
• Be sure to request inspections or repairs from the dealer where you purchased the unit or from qualified
Yamaha service personnel.
• Yamaha cannot be held responsible for injury to you or damage of the products caused by improper use or
modifications to the unit.
• This product is for ordinary homes. Do not use for applications requiring high reliability, such as
managing lives, health care or high-value assets.
WARNING
This content indicates "risk of serious injury or death."
If you notice any abnormality
• If there is a crack or damage in the unit, immediately request an inspection or repair from the dealer where
you purchased the unit or from qualified Yamaha service personnel. Continued use may cause the unit to fall
or tip over, resulting in injuries or damage.
Installation
• Assemble and install in the manner instructed in the manual. Falling or toppling may result in injury or
damage.
• Confirm that the finished installation is safe and secure. Also, carry out safety inspections periodically.
Failure to observe this may cause devices to fall and result in injury.
• Always fix the speaker cable to a wall or similar. If you catch your feet or hands on the cable, the speakers
may fall or overturn, causing malfunctions or injuries.
Fire warning
• Do not place any burning items or open flames near the unit, since they may cause a fire.
Handling
• Keep small parts out of the reach of infants. Your children may accidentally swallow them.
• Be careful not to drop or apply strong impact to this unit. Failure to observe this may cause injuries or
malfunctions.
• Do not use for purposes other than speaker stand. Otherwise, damage or injuries may result.
CAUTION
This content indicates "risk of injury."
Installation
• Do not place the unit in an unstable position where it might accidentally drop or fall over and cause injuries.
• Do not install the unit in other ways than indicated. Failure to observe this may cause malfunctions or for the
unit to fall and cause injury.
• Avoid being near the unit during a disaster, such as an earthquake. Since the unit may turn over or fall and
cause injury, quickly move away from the unit and go to a safe place.
• When transporting or moving the unit always use two or more people. Attempting to lift the unit by yourself
may damage your back, result in other injury, or cause damage to the unit itself.
• Do not use other screws than the ones included in the accessories. Otherwise, damage or injuries may result.
• Firmly tighten the screws. In addition, after a long period of use, check that no screws have become loose.
2
Otherwise, the speaker may fall, causing injuries.
• Before moving the speaker stand, remove the speaker. Otherwise, the speaker may fall, causing injuries.
Handling caution
• Do not do the following:
– Stand on or sit on the unit.
– Place the unit in a stack.
– Apply unreasonable force to the unit.
– Hang on the unit.
– Lean against the unit.
Failure to observe this may cause injuries or damage to the unit.
NOTICE
Indicates points that you must observe in order to prevent product deformation or damage to
the unit and so on.
Installation
• Do not use this unit in a location that is exposed to direct sunlight that becomes extremely hot, such as near
a heater, or extremely cold, or that is subject to excessive dust or vibration. Failure to observe this may cause
deformation or damage to the unit.
• Do not install the unit in places where it may come into contact with corrosive gases or salt air or places that
have excessive smoke or steam. Doing so may result in deformation or damage to the unit.
Do not disassemble
• Do not modify this unit. Failure to observe this may cause deformation.
Water warning
• Do not use in humid or damp conditions, such as a bathroom or outside in the rain. Otherwise, damage or
deformation may result.
Handling
• Do not place vinyl, plastic, or rubber products on this unit. Failure to observe this may cause discoloration or
deformation in the plate of this unit.
Maintenance
• If the temperature or humidity changes drastically, water droplets (condensation) may form on the unit
surface. If water droplets form, immediately wipe them off with a soft cloth. If water droplets are left on the
unit, they may be absorbed into the wooden parts, causing deformation.
• When cleaning the unit, use a dry, soft cloth. Using chemicals such as benzine or thinner, cleaning agents, or
chemical scrubbing cloths can cause discoloration or deformation.
INFORMATION
About content in this manual
• This manual is for the users of this unit.
• This manual uses the following signal words for the important information:
WARNING
This content indicates "risk of serious injury or death."
CAUTION
This content indicates "risk of injury."
NOTICE
Indicates points that you must observe in order to prevent product deformation or damage to the unit and so on.
NOTE
Indicates notes on instructions, restrictions on functions, and additional information that may be helpful.
• The illustrations in this manual are for instructional purposes only.
Yamaha Global Site
https://www.yamaha.com/
Yamaha Downloads
https://download.yamaha.com/
Manual Development Group
© 2020 Yamaha Corporation
10-1 Nakazawa-cho, Naka-ku, Hamamatsu, 430-8650 Japan