Cea Specifications; Amplifier Settings; Signal Input And Output Configurations; Input Gain - Orion COBALT CO300.2 Manuel Du Propriétaire

CEA SPECIFICATIONS

CO300 .2
CO600 .2
HIGH LEVEL HArNESSES
Do not connect the high level input connections to power, signal, or chassis ground as damage
to the head-unit outputs may result . The high-level inputs are designed to work with either
grounded or BTL speaker level outputs (found on most head units) .

AMPLIFIEr SETTINGS

Signal Input and Output Configurations

The input section of the amplifier consists of a phase switch that sets the output configuration,
gain controls, and rCA inputs . The input section makes it easy to adapt this amplifier to most
system configurations .

Input Gain

The Orion Cobalt CO300 .2 and CO600 .2 amplifiers have level adjustments to allow for easy
integration with any source unit . The input sensitivity can be adjusted from 75mV to 8V . refer
to Testing the System and Adjusting the Sound of the System sections of this guide for detailed
instructions on setting the gain .
© 2007 directed electronics—all rights reserved
Power Output: 60 Watts rMS x 2 at 4 ohms and < % THD+N
Signal to Noise ratio: -75 dBA (reference Watt into 4 ohms)
Additional Power: 80 Watts rMS x 2 at 2 ohm and < % THD+N
Power Output: 00 Watts rMS x 2 at 4 ohms and < % THD+N
Signal to Noise ratio: -75 dBA (reference Watt into 4 ohms)
Additional Power: 55 Watts rMS x 2 at 2 ohm and < % THD+N
HIGH LEVEL CONNECTIONS
WIrE COLOr
Black
White/Black
White
Gray/Black
Gray
INPUT CONNECTION
Ground
- Left channel
+ Left channel
- right channel
+ right channel
5