Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION INSTRUCTIONS
LP6N, LP8N, LP6HN, LP8HN, LP6FN, LP8FN, LF6N, LF8N
Installation:
TYPE NON-IC INSTALLATION ONLY: No insulation may be placed over the top of/or within 3"
(76mm) of the fixture.
1) Place (2) short hanger bars together so that the formed tabs slip into the slots to form one long rigid hanger
bar. Aligning
the "V" cutouts in the hanger bar will set the spacing for a 24" ceiling. (See Figure 1.)
2.) Assemble the hanger bars into the adjustable mounting brackets by sliding the mated long rigid hanger bar
through the tall vertical leg of the C-shaped cutout in the bracket and secure with the supplied hardware, the wing
nut facing away from the fixture for adjustment. (See figure 1.)
3.) Adjust the hanger bars as needed and tighten the wing nuts to secure the spacing. (See Figure 1.)
4.) Locate the T-bar slots near the ends of the bar hangers, bend the tabs out at 45 degree angle from the bar
hanger at each end. Snap the bar hangers over the ceiling T-bars for a secure fit. (See Figure 2.)
5.) Repeat this assembly for the opposite side of the fixture.
Wiring:
Prior to wiring the fixture, disconnect ALL power supplies to the unit.
Make all wiring connections inside the junction box. This fixture should be wired in accordance with NEC
and applicable local codes and ordinances.
1.) Remove the snap-on junction box captive door.
2.) Pry out the desired knockout with a flat blade screwdriver for hard wire access.
3.) Ballast Black wire connects to Line Voltage. Ballast White wire connects to the Neutral wire. The Ground
wire connects to the Bare Copper wire connected to the junction box. Bundle all wire into junction box.
4.) Close the snap-on junction box captive door.
Figure 1
Figure 2
Part No. CJ520240 Rev. A
Lithonia Lighting
©2008 Acuity Brands Lighting, Inc., 03/09
Downlighting
One Lithonia Way / Conyers, GA 30012
Page 2 of 3
800-315-4935 / www.lithonia.com
Publicité
