Safety Warnings; Safety Precautions - Craftsman CMXCAFG190643 Guide D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

English
CMXCAFG190643

SAFETY WARNINGS


WARNING: The sprayer is operated with liquid under
pressure. Failure to observe CAUTION and to follow
instructions for operating and cleaning can cause
tank, hose and other parts to be weakened and rupture
under pressure. This can result in serious injury from
high pressure discharge of liquids or forcible ejection
of parts. DO NOT USE FLAMMABLE MATERIALS IN THIS
SPRAYER. Material could ignite or explode, causing
serious injury and/or possible death. For safe use of
this product, you must read and follow all instructions
before use.

Test sprayer with water before using any chemicals.

SAFETY PRECAUTIONS: Read owner's manual
completely before operating this sprayer.
• Always wear safety goggles, gloves, and protective
clothing when using sprayer.
• Read and follow all instructions and cautions on label
of products used in this sprayer.
• Never use flammable liquids, caustics, acids, or hot
water in this tank.
• Do not leave sprayer in the sun when not in use.
• Spray when air is calm to prevent drift of chemicals.
• Do not use sprayer near open flame or anything that
could cause ignition of the spray.
• Always inspect the hose and all hose connections
before each use. A damaged hose, or loose hose
connection can result in unintended exposure to the
pressurized chemical, resulting in serious injury or
property damage.
• Do not lift or carry sprayer by the hose, shut-off valve,
or wand extension. Carry by pump handle only,
making sure handle is properly locked in place before
lifting.
• Do not pressurize with any mechanical device such
as an air compressor, since this can create dangerous
pressure level and bursting of parts resulting in
serious injury. Only use original or replacement pump
supplied by the original manufacturer.
• Do not store chemicals in this tank.
• Always release pressure when sprayer is not in use and
before removing pump from tank.
• Do not stand with face or body over top of tank when
pumping or loosening pump, to prevent pump and/or
solution from striking you, resulting in serious injury.
• Clean and rinse sprayer thoroughly after each use.
• Never attempt to alter sprayer from original condition.
• Always use replacement parts from original
manufacturer.
• Keep the sprayer and all chemicals out of the reach of
children and pets.
2
ASSEMBLY INSTRUCTIONS

WARNING: Do not attempt to heat or alter hose,
hose nut or barb prior to assembly.
It is recommended to test the sprayer using plain tap water
before spraying chemicals. Test all connections for possible
leaks. Use proper eye protection while testing. If sprayer does
not pass the water test, call our Customer Service Center before
using sprayer with chemicals. Make sure hose is not cracked or
frayed and does not show signs of swelling. Make sure hose is
securely connected to sprayer. DO NOT USE TOOLS TO TIGHTEN
HOSE NUT.
Assemble Hose to Tank
1a. Slide hose nut back on hose to expose hose barb.
2a. Push hose barb into tank until it stops. Align hose barb
tabs with cutouts in tank.
3a. Slide hose nut into place and turn clockwise to tighten.
2a
1a
Assemble Wand to Shut-off
1b. Install the wand onto the shut-off assembly and tighten
the nut securely.
1b
Install the Nozzle
Select using nozzle chart.
1
3
1
Dry-Touch
TM
Adapter
2
Cap Nut
3
Adjustable Cone Nozzle
3a
2
4
*Nozzle Styles May Vary
5
6
4
Low-Volume Foaming Nozzle
5
High Volume Foaming Nozzle
6
Wand

Publicité

Table des Matières
loading

Table des Matières