Mount Your Camera - nest Cam IQ Guide D'installation

Mount your camera

5. Install the wall plate
Use a 2 mm drill bit to drill pilot holes for
the screws
If the wall is made of a hard material like brick
or stucco, you may need to use the included
wall anchors to hold the screws Use a 6 mm
(7/32") bit for the anchors
Spread caulk around the edge of the wall plate
before installing to seal it Leave a small open
space at the bottom for water to drain out
• If you're installing the camera directly over
the cable hole (see illustration), mount the
wall plate over the hole and route the cable
through the center hole
• If you're running the cable along the wall
before it goes inside, mount the wall plate
where you want and route the cable through
the notch in the wall plate
10
6. Attach the camera
• Plug the end of the power cable that has the
gray rubber ring into the base of your camera
It will click into place
• Then push the camera base into the wall
plate until it clicks into place
• Your Nest Cam will turn on and reconnect
to Wi-Fi
• Check your camera's video feed with the
Nest app and adjust the camera angle
if needed