Regalo 0370BR Instructions De Montage page 4

STEP 7
RECEIVING COMPONENT
OUTER HOUSING
When you are satisfied with the general placement of
your gate, fully tighten the threaded spindle rods
attached to the lower corners of the gate by further
rotating the adjustment wheels. Continue by
tightening the upper threaded spindle rods. As you
tighten the threaded spindle rods, you will notice the
gap between the door frame and the arched handle
latch begin to narrow. In order for the gate to function
properly, stop tightening the upper threaded spindle
rods just before the outer housing of the arched
handle latch and the receiving component touch.
NOTE:
There should be equal spacing among each
of the (4) threaded spindle rods. Make the
appropriate adjustment to ensure you have installed
your gate safely.
Positioning and Attaching Wall Cups
STEP 1
After you have mounted your gate, and you are
satisfied with its positioning, draw a circle on the
surface of your doorway or opening around the
perimeter of the (4) rubber feet.
Next, completely remove the gate from the
opening by loosening each of the (4) threaded
spindle rods to depressurize the gate.
Operating the Door Latch
STEP 1
LOWER
TRIGGER
Pull up on the lower trigger while
simultaneously pulling back on the top slider
button. These two actions combined will
disengage the lock and allow the gate to
open freely.
Push or pull to open the gate door. To close,
simply push or pull the door back into its
original position. The arched handle latch will
re-engage automatically and lock the door into
its closed position.
NOTE:
If your arched handle latch is not
properly engaging with the receiving
component, ensure that your gate is level,
mounted properly, and that you have not
over-tightened the threaded spindle rods.
STEP 2
With gate fully removed, you can now use the circles
you marked during Step 1 as guides for screwing in
your (4) wall cups. Center each of the wall cups within
the guide circles and use the provided self-tapping
screws (G) to fasten them in place via the hole
through the center of each wall cup.
STEP 2
SLIDER BUTTON
BASE LOCK
At the bottom of the gate door, rotate the
base lock to the horizontal position. To
allow the door to swing open in only one
direction rotate the base lock on one side.
To allow the door to swing open in both
directions, rotate the base lock on both
sides.
NOTE:
Place lock down on side occupied
by the child.
STEP 3
Reinstall your gate in the doorway or
opening according to the instructions,
using the newly installed wall cups as
anchoring points for the (4) threaded
spindle rods.