Electrical Connection And Safety - Otto VREB7509-6 Manuel D'utilisation

Installation in a wall unit
1. After making the electrical connections,
insert the oven into the cabinet by pushing
it forward. Open the oven door and insert
2 screws in the holes located on the oven
frame. While the product frame touches the
wooden surface of the cabinet, tighten the
screws.
If the oven is installed under a hob:
2. The distance between the worktop
and the top panel of the oven must be
a minimum of 50 mm and the distance
between the worktop and the top of control
panel must be a minimum of 25 mm.
Worktop
min. 25 mm
min.
50 mm
3. The distance between the base of the
K
F
I H
G
J
Hob
Oven
A
E
D
J
hob and the top panel of the oven must be
a minimum of 10 mm for air circulation.

2.3. Electrical Connection and Safety

WARNING: The electrical connection
of this appliance should be carried out
by an authorised service person or
qualified electrician, according to the
instructions in this guide and in compliance
with the current local regulations.
WARNING: THE APPLIANCE MUST
BE EARTHED.
• Before connecting the appliance to the
power supply, the voltage rating of the
appliance (stamped on the appliance
identification plate) must be checked for
correspondence to the available mains
supply voltage, and the mains electric
wiring should be capable of handling the
appliance's power rating (also indicated
on the identification plate).
• During installation, please ensure
that isolated cables are used. An
incorrect connection could damage
your appliance. If the mains cable is
EN - 55
B
C
C
min.
10 mm