Parts And Features; Operating Your Coffeemaker - KENMORE ELITE KKECMGBSS Guide D'utilisation Et D'entretien

PARTS AND FEATURES

Fig. 1
coffee beans hopper
bean chute cover
lock/open
button for
bean chute cover
bean grid
selector knob
LCD display
window
filter basket &
removable
gold-tone filter
12-cup carafe
warming plate
base
scoop & brush
hopper lid
water
reservoir
control panel
with backlit
buttons
release button
for filter basket
door
water
reservoir
window
housing
water filter
carriage
charcoal
water filter
4
PREPARING TO USE YOUR COFFEEMAKER
• Before the rst use of the co eemaker wash the brew basket, the permanent gold-tone lter, the
carafe and carafe lid in either the top rack of your dishwasher, or by hand in warm, sudsy water.
• The exterior of the co eemaker, the control panel area and the warming plate should only be
cleaned with a soft damp cloth.
NOTE - NEVER clean the warming plate unless it is completely cool.
NOTE - DO NOT use abrasive cleansers or scouring pads when cleaning the unit.
NEVER immerse the co eemaker in water or any liquid.
After all parts are washed for the rst time, pour cold water up to the 12 cup level mark in the
water reservoir. Brew it through the co eemaker as instructed in BREWING COFFEE, but do not
add co ee grounds to the lter. When done, turn o the co eemaker and discard the water from
the carafe. This will remove any possible residue left over from the manufacturing process.

OPERATING YOUR COFFEEMAKER

CONTROL PANEL
ON/OFF
If you want to start or stop the current operation, you need to press the ON/OFF button. The
button LED is either on or o to indicate operating status. When the machine is in brewing mode,
the Grind O , Program, Hour, Min, 2-12 Cup and Strength buttons cannot be used. However,
other buttons that do not a ect the current grind and brew procedure can be pressed.
PROGRAM
Brie y press this button to start or stop the delay brew after setting the current time and delay
brew time. The PROG button LED will turn on or o accordingly. After setting the current time,
long press the PROG button, then enter the delay brew setting state. The initial setting is "12:00
PM", 10 cups, medium strength, grind and brew. Now press the "Hour" button, then "Min"
(minutes) to set the delay brew time. If no operation is performed for 10 seconds, the brew delay
setting is set. Brie y press the PROG button to start the delayed brew.
HOUR
Button for setting the time. Press the HOUR button to set the hour. The setting range can be 0-12
AM-PM. The clock stops running during this time, the second digit displays zero, and if you set the
time for brew delay, then brew delay times will display.
5