Hubbell Prescolite CFR EB Mode D'emploi

IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information
and instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials,
a n d p o r p r e a l m p n i . g D o n t o
during servicing or relamping, turn off power at fuse or circuit breaker. All servicing or relamping must be performed by
qualified service personnel. Product must be grounded to avoid potential electric shock or other potential hazard.
Product must be mounted in locations and at heights and in a manner consistent with its intended use, and in
compliance with the National Electrical Code and local codes. The use of accessory equipment not recommended by
the manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light emanating from
product in whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains, screens or
the like to come into contact with the product or to block light from the product, as this may cause an unsafe condition.
INSTALLATION INSTRUCTIONS
1. Bend brackets as shown in detail "A".
Install the fixture in the ceiling using
mounting channel or bar (byothers)
placed in the adjustable mounting brack-
ets. Mount the fixture in the ceiling so
that the weight of the fixture is support-
ed by the mounting channel or bar and/
or hanger wires secured to the building
structure.
2. Adjust the fixture so the bottomof the
plaster frame is flush with the ceiling line
and in alignment with adjacent fixtures.
Secure mounting brackets by tightening
wing nuts on either side of the fixture.
3. Remove J-Box cover(s) and determine
where the supply wiring conduit will
enter the J-Box. CAUTION: CONDUIT
CONNECTORS MAY INTERFER
WITH COMPONENTS HOUSED IN
THE J-BOX CHECK CLEARANCES
BEFORE REMOVING KNOCKOUTS.
Attach the Conduit in conformance with
the National Electric Code.
4. Remove J-Box cover plate. Remove
appropriate knockout and assemble
appropriate connector for the supply
wire used. Connect ground wires to
green ground leads. Connect white
(common) to white (leads). Connect
power supply (line) to black lead(s).
Reinstall J-Box cover.
WARNING: DO NOT pinch wires
between J-Box/ballast cover and
J-Box. Consult a Qualified Electrician
for all other options that require other
wiring configurations.
5. Install the reflector after all ceiling
installtion and finishing work is com-
plete. Push reflector into plaster frame
and align with threaded stud. Secure
reflector with wing nut and tighten until
reflector flange is flush to ceiling.
6. Install the proper lamps (by others).
CAUTION: DO NOT ATTEMPT TO MODIFY OR REWIRE FACTORY-INSTALLED WIRING ON THE FIXTURE. SAFETY AND
PROPER OPERATION OF THE FIXTURE DEPEND ON THE INTEGRITY OF THE WIRING.
701 Millennium Boulevard • Greenville, SC 29607
With representatives offices in principal cities throughout North America.
Copyright 2018, 6/21/18 revision, All Rights Reserved - Printed in U.S.A.
n i t s l l a n i a e r a s s u b e j t c o t c o
CFR EB/EBDMCP
Bend brackets in
line with marks
on flange.
DETAIL A
Plaster Frame
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 06286500
m b u t s b i e l v a p o s r r o g a s e . s
JBox
B e o f e r w r i n i g o t p o w r e s u p p
J-Box Covers
Mounting
Bracket
Secure Reflector
to Threaded Stud
with Wing Nut
(Not Shown).
Reflector
Reflector Flange
Page 1 of 2
y l a n d