Publicité
Les langues disponibles
Les langues disponibles
Welcome to the World of Treasure Tracking:
Your new Treasure Tracker
hobby. The Treasure Tracker
coins, pieces of jewelery, and other metal objects. It can also be
used to hunt for relics from long ago. It's FUN too!
Contents:
1. Search Coil
2. Battery Compartment
3. Body
4. Shaft
5. Handle
6. LCD Information Screen
7. Locking Ring (2)
8. Sensitivity control
9. ON/OFF Volume Control
Be a Good Citizen:
Obey all laws. Using a metal detector is against the law at most national, state, and provinicial parks.
If you live in a city or town there may be local laws that tell you where you can use a metal detector.
Always ask for permission from the property owner before you do any detecting on private property.
Do not trespass.
When you find a metal object you may have to dig a small hole to retrieve it. Keep such holes as
small as possible and fill them in neatly when you are finished.
Getting Started:
1. Insert a 9 volt alkaline battery in the body of the Treasure Tracker
screwdriver to remove the battery compartment cover. Attach the battery to the battery terminal
clip, making sure that the (+) and the (-) terminal are properly identified. Replace the battery
compartment cover and re-insert the screw. Do not over-tighten.
BATTERY WARNING:
• Do not mix alkaline, standard (carbon-zinc) and rechargeable batteries (nickel hydride).
• Do not mix old and new batteries.
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the appliance before being charged
(if removeable).
• Rechargeable batteries are only to be charged under adult supervision (if removeable).
• Exhausted batteries are to be removed.
• The supply terminals are not to be short circuited.
• Only batteries of the same or equivalent type as recommended are to be used.
• Batteries are to be inserted with the correct polarity.
2. The Treasure Tracker
metal detector that you use while standing up-or you can convert it into a smaller, hand held unit
for searching in confined areas.
3. FULL-SIZE: Insert the shaft into the body by turning the shaft clockwise. Now attach the handle
to the top end of the shaft by turning the handle clockwise down onto the shaft.
4. HAND-HELD: Remove the handle and the shaft by turning the handle counter-clockwise out
2
can start you in an exciting new
™
can be used to find missing or lost
™
can be used in two different ways. You can assemble it into a full size
™
5
7
3
8
6
. You will need a phillips head
™
4
9
2
1
Publicité
